How to Insulate the Backflow Preventer on Sprinkler System

Things You\’ll Need

  • Duct tape

  • R-11 fiberglass insulation

  • Black trash bag

  • Backflow insulation bag

... Place excess insulation in the valve manifold to protect irrigation valves.

During the winter, the backflow preventer on your irrigation system should be completely drained of water to prevent internal freezing, which can cause various parts of the system to break. After drainage of the preventer and the entire irrigation system, you may wish to insulate certain parts of the system, including the preventer, to further protect them from the harsh weather.

Video of the Day

Low-Cost Solution

Step 1

Wrap R-11 fiberglass insulation all around the components of the backflow preventer, being careful not to cover the drain outlets and air vents of the unit. While the preventer is wrapped up for the winter, the unit needs to drain and air-out sporadically. If necessary, cut the fiberglass to better fit it around the unit. Towels can be substituted for insulation, if necessary. Use duct tape to keep the insulation wrapped around the preventer.

Step 2

Cover the backflow preventer and the fiberglass insulation with a black trash bag to secure the insulation, add further insulation and prevent the fiberglass insulation from getting wet. As with the fiberglass insulation, keep preventer drains uncovered. A heavier plastic can be used, if you don't trust the quality of a trash bag to last all winter.

Step 3

Wrap the insulation and the trash bag in duct tape securely enough to keep the setup in place through the winter but not too tight. Toward the ends of the unit, keep a small opening around the pipes to allow air to pass into the unit.

Ready-Made Solution

Step 1

Place a ready-made insulation blanket or bag over the top of the backflow preventer unit. A ready-made insulation bag might consist of fiberglass set in between two sheets of fabric with a durable outer cover. Leave space for drainage and airflow.

Step 2

Loosen the bag so that it's clear of drainage holes and air can flow through bottom of the bag. The preventer must be able to drain throughout the winter, if necessary.

Step 3

Tie the strings of the insulation bag below the backflow preventer. If the insulation bag features a snap at the bottom, then snap the bag closed and confirm the bag is unable to fly off of the preventer during strong winds. Some insulation bags come with padlocks to secure the bag to the preventer. If this is the case, then lock the padlock into place below the preventer.