Things You\’ll Need
Toy car wheels
Tongue depressors or Popsicle sticks
Clothespins or clamps
Scrap wood blocks (1 inch x 1 inch x 1/4 inch)
Power drill and assorted bits
Milk jug lids
CDs or plastic CD toppers
Hot glue and glue gun
Mousetrap race carMegan Andersen
Making a mousetrap car is a fun way to experiment with materials around the house while learning about physics.
Video of the Day
Making pilot holes for the nails.Megan Andersen
Use a nail to press a hole in each side of the mousetrap. (These holes act as guides and help keep the wood from splitting.) Nail the toy wheels to the sides of the mousetrap at the front of the trap. Leave a little space between the trap and the wheel when you hammer in the nail, so the wheels can rotate freely.
Center drilled holesMegan Andersen
Draw two Xs on the 1-inch wood blocks, using a pencil and straight edge. At the intersection of each X, drill a hole slightly larger than the wood dowel.
Let the wood glue dry completely.Megan Andersen
Glue two Popsicle sticks to the bottom of the mousetrap, aligned with the sides of the mousetrap and extending from the end opposite the wheels. Glue the wood blocks on top of the Popsicle sticks. Hold the Popsicle sticks in place while they dry, using either clamps or clothespins. Allow the glue to cure completely (about 6 hours).
Carving the dowel.Megan Andersen
Cut a length of wood dowel about 3 inches longer than the width of the mousetrap. Carve a small notch in the center of the dowel.
Create the back wheels.Megan Andersen
Slide the wood dowel through the holes in the wood blocks. Drill a hole in the center of the milk jug lids, then slip the CD toppers and milk jug lids onto the dowel. Wrap rubber bands around the dowels to secure the assembly.
Hot glue the rubber bands in place.Megan Andersen
Apply a generous amount of hot glue inside the milk jug lid and around the rubber band. This will secure the "wheel" to the "axle." Be careful not to glue the CD topper to the wood blocks. You want these "back wheels" to spin freely.
View of the axle.Megan Andersen
Check to make sure both wheels spin freely. Pry away any stray glue, if necessary. Cut a piece of fishing line about 6 inches long and tie one end to the metal bar of the mousetrap.
Set the trap and watch the car roll.Megan Andersen
Pull the trap bar back toward the back wheels, and wrap the fishing line around the center of the axle and the notch. Gently place the car on a hardwood or linoleum floor, and release your hand from the trap. The car should propel forward and roll for several feet.
Using CD toppers is a way to reduce the friction between the wheel and floor. Friction will cause the car to slow down quickly, and therefore travel a shorter distance.
Be very careful when working with the mousetrap. If you look away from what you are doing during this project, you could snap your finger in the mousetrap.